G
Gaurav
Guest
In the past I had very bad experience regarding data restoration from
NTbackup Full system backup file.
I am using Windows 2k3 & 2K server both.
I am using Dell power edge 6600, 6650 &1850 servers.
When the server OS crashes I used to do following steps
1. First I install OS.
2. Install service pack same as old O/S has & all security
patches.
3. After that restore full backup from tape
But after completion of this when I restore full backup of server
through Ntbackup
Some times server restarts again & again continuously or sometime few
of the services or application of servers not runs properly.
I am restoring from FULL backup set.
At the time of backing up the server there were no file skipped in
report
Where do I m making mistake.
Thanks in advance
With Regards,
Gaurav Mathur
NTbackup Full system backup file.
I am using Windows 2k3 & 2K server both.
I am using Dell power edge 6600, 6650 &1850 servers.
When the server OS crashes I used to do following steps
1. First I install OS.
2. Install service pack same as old O/S has & all security
patches.
3. After that restore full backup from tape
But after completion of this when I restore full backup of server
through Ntbackup
Some times server restarts again & again continuously or sometime few
of the services or application of servers not runs properly.
I am restoring from FULL backup set.
At the time of backing up the server there were no file skipped in
report
Where do I m making mistake.
Thanks in advance
With Regards,
Gaurav Mathur