Broadcast Wifi Over Pci Nic?

[iphonogasm]

so im using microsoft network monitor to monitor all traffic in and out (public) and mirrored ports for local traffic, except wireless traffic as its connecting to the router.

I want to use a wifi NIC on the server to broadcast, so wireless clients can connect via the server and obtain DNS and DHCP etc from there, therefor, monitoring all traffic.

Below is a diagram. Is this possible?

Thanks!

View attachment 177

 

[iphonogasm]

ok so i still cant get this to work, managed to get the PCI card to broadcast etc over a ad-hoc setup, but i dont think this is the way to go.
With an ad-hoc, is it computer to computer, meaning only one computer can connect to it at a time? also i cant even get one computer connected, it says failed to connect to netwrok!
Thanks

 

[ICTCity]

Simply add your Nic, enable router role, or configure it, then route from WiFi to Ethernet. Use the built in program to configure ad-hoc network

 

[iphonogasm]

thanks, at the moment i have the wireless NIC added to the bridge connection.

Where is the router role? is it a role as such cause when i go to add role services its no where to be found

Thanks!

 

[iphonogasm]

some help on this would be really great. I have removed the wireless connection from the bridge, but in RRAS when i try add "New Interface" it says there are no new avaliable interfaces. also when i try add a new routing protocol the only interface i can add is the Network Bridge,

So, i have the wireless NIC on its own (Not in the Brige) and have setup an ad-hoc network, set an SSID and WPA key etc. However when i try connected from a wireless device, it fails to connect. Im guessing i willl also have to setup the device to assign DHCP from the server too

Thanks!