error message after application installation

W

wiseyuss

New member
Joined
Feb 26, 2006
Messages
3
I have created a Windows application using VS 2003 and used the setup wizard for deployment purposes. It runs perfectly well on my machine but after I install the application on another machine and try to start it I get an error that says;

"Application has generated an exception that could not be handled.
Process ID 0x450 (1104), Thread ID 0x3a8(936)."

What have I messed up.

Shawn the desparate programmer
 
yes I have install the .net framework. It must be something simple though because it runs fin on my laptop where I do all my programming.

By the way. My application is a MS Access database application that also uses Crystal reports. I think it may be a crystal reports issue as previos verious seem to run fine. It is only since I incorporated CR that the problem came up.
 
Have you included the CR support in your installer? If not search these forums as its a topic that has cropped up several times before.
 
Back
Top