IDE Controller Problems

  • Thread starter Thread starter Hans
  • Start date Start date
H

Hans

Guest
Hello all I just recently put two more drives in my pc, and in order to do
that I needed an IDE controller so I went out and bought one. I used the IDE
controller cd-rom to install the driver and it installed the "Silicon image
SiI 0680 ATA/133 RAID Controller" but I still cant see my drives , not even
in the storage manager, I flashed my bios on my M2N-SLI Deluxe to the newest
one and it's still not working. I have four drives two of which are plugged
into the controller. I've tried installing different versions of the driver
but when I update it says that the currently installed driver is better. I
now notice that I have a section in the control panel named Silicon Image ATA
Controllers. I opened the panel up and there are the tabs "device info" and
"Flash BIOS" and an empty window above saying "Avalible Controllers" with
none listed, all options in this panel are grayed out.

If anyone has any ideas, it would be much appreciated.
 
Re: IDE Controller Problems

I have not tried using a card like that for pure IDE hard drives unless they
were RAID'ed. First thought that comes to mind is that you need to enter
BIOS Setup when booting and configure your HD's to the actual connectors
where they are attached, and make sure that all connectors that don't have
anything attached are disabled. In fact, it's a good idea (not neccessarily
for this issue?) to disable anything in your BIOS that you are not using -
like serial and parallel ports and stuff.

It may be a good idea to read the BIOS section of your motherboard manual
carefully so you don't miss anything obvious.

AND! - perhaps you should pull any USB flash drives and card-readers before
your first boot?


Tony. . .



"Hans" <Hans@discussions.microsoft.com> wrote in message
news:FF9B02F2-B0E0-4AD6-8B07-98D3015CFC33@microsoft.com...
> Hello all I just recently put two more drives in my pc, and in order to do
> that I needed an IDE controller so I went out and bought one. I used the
> IDE
> controller cd-rom to install the driver and it installed the "Silicon
> image
> SiI 0680 ATA/133 RAID Controller" but I still cant see my drives , not
> even
> in the storage manager, I flashed my bios on my M2N-SLI Deluxe to the
> newest
> one and it's still not working. I have four drives two of which are
> plugged
> into the controller. I've tried installing different versions of the
> driver
> but when I update it says that the currently installed driver is better. I
> now notice that I have a section in the control panel named Silicon Image
> ATA
> Controllers. I opened the panel up and there are the tabs "device info"
> and
> "Flash BIOS" and an empty window above saying "Avalible Controllers" with
> none listed, all options in this panel are grayed out.
>
> If anyone has any ideas, it would be much appreciated.
 
Back
Top