install but cannot boot up win2000 using ich9do

  • Thread starter Thread starter aclhkaclhk
  • Start date Start date
A

aclhkaclhk

Guest
I have a motherboard, gigabyte (ga-q35-s2) using this controller:

Intel Corporation 82801IR/IO/IH (ICH9R/DO/DH) 4 port SATA IDE
Controller (rev 02)

harddisk: 320G, sata2

formating and copying files to harddisk are ok but after reboot:

invalid boot.ini
booting from c:\winnt
ntdetect failed

Pls kindly advise.
 
Re: install but cannot boot up win2000 using ich9do

You'll need to start over.

http://www.intel.com/support/chipsets/imsm/sb/CS-021736.htm



--

Regards,

Dave Patrick ....Please no email replies - reply in newsgroup.
Microsoft Certified Professional
Microsoft MVP [Windows]
http://www.microsoft.com/protect

"aclhkaclhk" wrote:
>I have a motherboard, gigabyte (ga-q35-s2) using this controller:
>
> Intel Corporation 82801IR/IO/IH (ICH9R/DO/DH) 4 port SATA IDE
> Controller (rev 02)
>
> harddisk: 320G, sata2
>
> formating and copying files to harddisk are ok but after reboot:
>
> invalid boot.ini
> booting from c:\winnt
> ntdetect failed
>
> Pls kindly advise.
 
Re: install but cannot boot up win2000 using ich9do

On Mon, 21 Jan 2008 02:42:17 -0800 (PST), aclhkaclhk
<access_you@yahoo.com> wrote:

>I have a motherboard, gigabyte (ga-q35-s2) using this controller:
>
> Intel Corporation 82801IR/IO/IH (ICH9R/DO/DH) 4 port SATA IDE
>Controller (rev 02)
>
>harddisk: 320G, sata2
>
>formating and copying files to harddisk are ok but after reboot:
>
>invalid boot.ini
>booting from c:\winnt
>ntdetect failed
>
>Pls kindly advise.
You have to provide more details as to what steps you have taken
during Windows setup.
In bios setup what is SATA Port0-3 Native Mode (Intel ICH9DO
Southbridge) set to?
I'm assuming the partition you're installing to is 128G or smaller?
 
Back
Top