Windows 2008-0.0.0.0 IP address

  • Thread starter Thread starter Steve
  • Start date Start date
S

Steve

Guest
I upgraded from windows 2003 to windows 2008 (enterprise edition for
both)...and upgrade was fine (all drivers updated too). when I put in the IP
address...and click ok...the IP and subnet mask go to 0.0.0.0. the gateway
and dns server stays. i go to the 2nd tab (tcp v4), and I see 0.0.0.0 for the
IP, then the 10.5.x.x that I entered. I remove the 0.0.0.0 and go back to the
original box..and I see it the way I set it up. I click ok..and the same as
before. Is there some type of ipautoconfiguration or something that keeps
putting this 0.0.0.0 in there..and how can I turn it off? this is just a test
server. any help is appreciated. it is a dell2650, broadcom netxtreme and
intel xt NICs (no teaming). thanks. steve
 
RE: Windows 2008-0.0.0.0 IP address

Steve, did you ever get this resolved. I'm having the same issue.

"Steve" wrote:

> I upgraded from windows 2003 to windows 2008 (enterprise edition for
> both)...and upgrade was fine (all drivers updated too). when I put in the IP
> address...and click ok...the IP and subnet mask go to 0.0.0.0. the gateway
> and dns server stays. i go to the 2nd tab (tcp v4), and I see 0.0.0.0 for the
> IP, then the 10.5.x.x that I entered. I remove the 0.0.0.0 and go back to the
> original box..and I see it the way I set it up. I click ok..and the same as
> before. Is there some type of ipautoconfiguration or something that keeps
> putting this 0.0.0.0 in there..and how can I turn it off? this is just a test
> server. any help is appreciated. it is a dell2650, broadcom netxtreme and
> intel xt NICs (no teaming). thanks. steve
 
Back
Top